Roger Mayer - Voodoo Blues Pedal

Roger Mayer - Voodoo Blues Pedal

Roger Mayer - Voodoo Blues Pedal

AED. 1,799.00

The output level is high enough to drive the 1st Stage of Tube Amplifiers into distortion if required and the Fatness control does what it says and is not just a simple EQ section.

It has all the usual features of our Voodoo-Series pedals and is a welcome addition to the range.

Don't imagine that it can only be used for Blues as its characteristics lend itself very well to Rock and Country as well.

The Voodoo-Blues is housed in our Standard Style enclosure with both dual direct drive buffered outputs or hard wire output and has a rapid change 9V battery compartment.
Extensive internal filtering ensures that noise free operation is maintained even with the most basic of adapters.

DUAL DIRECT DRIVE OUTPUTS are provided capable of driving very long leads without any loss and in fact you could use a speaker lead for the outputs if you want without any hum.
This feature feature is standard on all our voodoo series and in effect reduces the output lead length to zero. This results in GREATER DETAIL and FIDELITY than using two long lengths of guitar leads in traditional hard wire bypass set-ups. The problem of CABLE NOISE induced by vibration on stage is eliminated together with electrical magnetic interference induced into shielded cables from lighting rigs etc. Possibly of more importance there is no TONE SUCKING at all from the output length of guitar cable. After all the ULTIMATE GUITAR CABLE would have a lead length of zero, and guitar players can detect the difference between long and short cables easily. The overall signal quality in the unit is thus guaranteed right up to amplifier and this overall performance exceeds any other method in use today. When using a Voodoo-Bass as the last device in a signal chain the distance to the amp does not come into consideration and long leads can be used successfully in recording situations e.g.: playing in the control room.

TRADITIONAL HARD WIRE OUTPUT /BYPASS is provided as well to enable comparison between using a BUFFERED OUTPUT in your particular set-up.